Intel DQ965WC Product Specification - Page 59
Auxiliary Front Panel Power LED Header
View all Intel DQ965WC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Technical Reference 2.7.2.3.2 Reset Switch Header Pins 5 and 7 can be connected to a momentary single pole, single throw (SPST) type switch that is normally open. When the switch is closed, the board resets and runs the POST. 2.7.2.3.3 Power/Sleep LED Header Pins 2 and 4 can be connected to a one- or two-color LED. Table 27 shows the possible states for a one-color LED. Table 28 shows the possible states for a two-color LED. Table 27. States for a One-Color Power LED LED State Description Off Power off/sleeping Steady Green Running Table 28. States for a Two-Color Power LED LED State Description Off Steady Green Steady Yellow Power off Running Sleeping NOTE The colors listed in Table 27 and Table 28 are suggested colors only. Actual LED colors are product- or customer-specific. 2.7.2.3.4 Power Switch Header Pins 6 and 8 can be connected to a front panel momentary-contact power switch. The switch must pull the SW_ON# pin to ground for at least 50 ms to signal the power supply to switch on or off. (The time requirement is due to internal debounce circuitry on the board.) At least two seconds must pass before the power supply will recognize another on/off signal. 2.7.2.4 Auxiliary Front Panel Power LED Header Pins 1 and 3 of this header duplicate the signals on pins 2 and 4 of the front panel header. Table 29. Auxiliary Front Panel Power LED Header Pin Signal Name In/Out Description 1 HDR_BLNK_GRN Out 2 Not connected Front panel green LED 3 HDR_BLNK_YEL Out Front panel yellow LED 59