Intel SCB2 Product Guide - Page 73
Restricted Mode Access, System Phone Number
![]() |
UPC - 735858148962
View all Intel SCB2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Help Topics The Help Topics menu has the following options: • Help Topics: Displays help information. Enter New Password Enter an EMP password. The valid range of characters includes ASCII values 32-126. The password must be from 1-16 characters long. Verify New Password Enter the same password as above. ESC Sequence The ESC Sequence string is sent to the modem before sending a command string to the modem. The length of the paging string is determined at run-time from firmware. You will be notified if the string is truncated. The string that has been saved is the one that will be shown in the edit box. Hangup String The Hangup Line string is sent to the modem whenever the EMP wants to terminate the session. The EMP automatically sends an character after this string. The length of the paging string is determined at run-time from firmware. You will be notified if the string is truncated. The string that has been saved is the one that will be shown in the edit box. Modem Init String The Modem Init String string is transmitted every time the EMP initializes. The length of the paging string is determined at run-time from firmware. You will be notified if the string is truncated. The string that has been saved is the one that will be shown in the edit box. System Phone Number Enter the system telephone number. This can be retrieved and reported via in-band management connections. Access Mode In Pre-boot Only the EMP is automatically activated when the system is powered-down or hard reset. In Always Active the EMP is active when the system is powered-down or hard reset. In Disabled the EMP powers-up deactivated and is not automatically activated by BIOS, power-down or hard resets. Restricted Mode Access When restricted mode is enabled control operations that could disable or alter a running system via the EMP are disabled. Connection Mode Direct connect mode is for applications that connect the port directly to another computer system, while Modem Mode is for applications where the port is connected to an external modem. Configuration Software and Utilities 73
![](/manual_guide/products/intel-scb2-product-guide-5949964/73.png)