Intel SE7210TP1-E User Guide - Page 24

Server Installations and Upgrades Removing the Processor To remove the processor, follow these instructions: 1. Observe the safety and ESD precautions at the beginning of this document. 2. Disconnect the processor fan cable. 3. Open the levers on the heat sink. 4. Disengage the retention mechanism hooks at the bottom of the heat sink. 5. Lift the heat sink from the processor. 6. Lift the processor lever. 7. Remove the processor. Installing a PCI Card Peripherals and add-in cards are not included in your system and must be purchased separately. The PCI slots support full-height add-in cards or low profile PCI add-in cards. If a low profile card is installed in the standard full-height riser card, it must be equipped with a standard full-height PCI mounting bracket. 1. Remove the screw that attaches the PCI bracket shield to the rear of the chassis to remove the shield. Retain the screw. 2. Insert the PCI card into the PCI slot. Tipping it in the slot while installing it may damage the PCI card or slot. 3. Use the screw removed in step 1 to secure the PCI card to the chassis. Replacing the Backup Battery The lithium battery on the server board powers the RTC for up to 10 years in the absence of power. When the battery starts to weaken, it loses voltage, and the server settings stored in CMOS RAM in the RTC (for example, the date and time) may be wrong. Contact your customer service representative or dealer for a list of approved devices. WARNING Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions. ADVARSEL! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren. 24 Intel Server Board SE7210TP1-E User Guide