Intermec PD42 PD41 and PD42 Commercial Printer User's Manual - Page 26
Loading Media for Peel-Off (Self-Strip) Printing - calibration
View all Intermec PD42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 1 - Using the Printer 3 Load a media roll onto the media supply hub. Be sure to push the roll all the way against the inner wall of the printer and adjust the edge guide. 4 Route the media through the print mechanism. 5 If you are using fanfold media, load it through the external media slot at the rear of the printer and route it the same way as you would a media roll. 6 Reset the label feed guide and the printhead lever. 7 Close the media cover. 8 Press the Print button to advance the media. If you are switching Test to a new type of media, you must run a Testfeed ( ) to calibrate the sensors on the printer. Loading Media for Peel-Off (Self-Strip) Printing Use the procedure in this section when you are using self-adhesive labels that are separated from the liner immediately after printing. Peel-off printing is also called self-strip printing. With peel-off printing, you use the label taken sensor to sense when a label has been removed. After a label is removed, the sensor lets the printer know it is okay to print another label. Peel-off printing only supports selfadhesive labels with a liner. 12 PD41 and PD42 Commercial Printer User's Manual