Intermec PD42 PD41 and PD42 Commercial Printer User's Manual - Page 46
Configuring 802.11 Wireless Security Using Fingerprint
View all Intermec PD42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Chapter 2 - Connecting the Printer 5 If you are using TTLS, you may need to send this command to set the TTLS outer name: ws,TTLS_USER, xxxx where xxxx is the outer name. 6 If you are using certificates for validation, here are some commands you may need to use. • Send the following commands to set a certificate and enable validation: ws,CA_CERT,c:/testCA.pfx@export ws,VALIDATE,ON where c:/testCA.pfx is the location and name of the certificate and export is the passphrase. • Send the following commands to set a common name for server 1 and server 2: ws,.SERVER_CN1,xxxxxxxxxx ws,.SERVER_CN2,xxxxxxxxxx where xxxxxxxxxx can be a value from 0 to 64 characters. • Send the following command to make sure your values match those used by the access point: wt,[variable name] All variables are returned with the exception of EAP_PASS which always returns "****" if configured and CA_CERT which transmits the name of the last certificate authority successfully installed. An additional read-only variable for the supplicant state, called STATE, is also returned. • You may need to send the following command several times for the wireless station to connect: ws,ACTIVE,1 Configuring 802.11 Wireless Security Using Fingerprint Use the following procedures to configure 802.11 wireless security parameters on your printer using IPL. 32 PD41 and PD42 Commercial Printer User's Manual