Intermec PD42 PD41 and PD42 Commercial Printer User's Manual - Page 43
Configuring 802.11 Wireless Security Using IPL, Configuring 802.11, Wireless Security Using IPL
View all Intermec PD42 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 - Connecting the Printer wt,WEP1 wt,PAC wt,ACQUIRE_PAC wt,WEP2 wt,WEP3 wt,WEP4 wt,AUTH wt,WPA wt,WPA2 wt,WPA_PSK wt,ROAM wt,CHANNEL wt,AP_MAC wt,SIGNAL wt,SPEED wt,ACTIVE If you are using Fingerprint, send this command to the printer: setup write "wlan","uart1:" setup write "8021x","uart1:" 4 Set up the printer to use the correct SSID and authentication modes. For help, see the next section, Configuring 802.11 Wireless Security Using IPL or "Configuring 802.11 Wireless Security Using Fingerprint" on page 32. 5 If you are going to use certificates for validation, transfer the certificate to the printer. The printer can accept .pfx, .pem, and .der certificates. 6 Verify that the printer is connected to the access point and make sure it has an IP address allocated to it. Use the following sections to set most of your wireless communication settings. For help with additional commands and information, see either the Intermec Fingerprint Command Reference Manual or the IPL Command Reference Manual. You can download both documents from the Intermec web site at www.intermec.com. Configuring 802.11 Wireless Security Using IPL Use the following procedures to configure 802.11 wireless security parameters on your printer using IPL. PD41 and PD42 Commercial Printer User's Manual 29