Intermec SR31T SR31T Tethered Scanner User's Guide - Page 32

USB Cable Mode, Status Light

Get Intermec SR31T PDF manuals and user guides View all Intermec SR31T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Chapter 3 - SR31T Interfaces USB Cable Mode By default the USB cable mode is set to Keyboard HID. However you can also set up your scanner to use the following USB cable modes: • HID POS • IBM POS Hand Held • IBM POS Table Top • Virtual COM USB Keyboard HID (*) ) HID POS IBM POS Hand Held IBM POS Table Top USB Virtual COM Note: When scanning a USB Cable Mode configuration bar code, the scanner beeps twice then restarts. When it restarts, the scanner will beep twice, flash a series of green flashes to indicate the USB cable mode selected (see "Status Light" on page 11), and vibrate. 24 SR31T Tethered Scanner User's Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
Chapter 3 — SR31T Interfaces
24
SR31T Tethered Scanner User’s Guide
USB Cable Mode
By default the USB cable mode is set to Keyboard HID. However you
can also set up your scanner to use the following USB cable modes:
•
HID POS
•
IBM POS Hand Held
•
IBM POS Table Top
•
Virtual COM
USB Keyboard HID (*)
)
HID POS
IBM POS Hand Held
IBM POS Table Top
USB Virtual COM
Note
: When scanning a USB Cable Mode configuration bar code, the
scanner beeps twice then restarts. When it restarts, the scanner will
beep twice, flash a series of green flashes to indicate the USB cable
mode selected (see
“Status Light” on page 11
), and vibrate.