JVC DR MV79B Instructions - Page 190

Remote Control Function Remote Control A/B/C/D Code Switching The remote control is capable of controlling four JVC video units independently. Each of the units can respond to one of four codes (A, B, C or D). The remote control is preset to send C code signals because your unit is initially set to respond to C code signals. You can easily modify your unit to respond to A, B or D code signals. Note: If you change the batteries of the Remote Control with A, B or D code, the remote control code is set to C automatically. In this case, you should reset the remote control code described above. B/`` STANDBY/ON (1/&) Number 1-4 STOP (x) ENTER ( ) RM-SDRMV150A 1. Press STANDBY/ON (1/&) on the unit to turn off the unit with no video tape inserted. 2. Press the number key "1" for A, "2" for B, "3" for C or "4" for D while pressing ENTER ( ) down on the remote control. 3. Press N/`` on the unit for over 5 seconds while the unit is turned off. The current code appears on the display window. 4. Press STOP (x) on the remote control, the current code on the display window changes to new code and blinks for approximately 10 seconds. 5. The new code setup on unit and remote is done. 8