JVC TK-C553U Instruction Manual - Page 14

SYSTEM System with Remote Control Unit RM-P2580 Settings Ⅲ CAMERA FACE MONITOR LOCK LEFT AWC INT OFF TERMINATION UP RIGHT SET NOT USED NOT USED L/L ON DOWN INT LL OFF ON TERMINATION • Video synchronization selector switch (INT/LL) Set to LL (Line Lock) on all cameras, and align V.PHASE. (੬ See page 29.) • Control signal termination ON/OFF switch (TERMINATION OFF/ON) Set this to ON only on the camera placed at the end of the control signal cable. Set to OFF on all other cameras. Menu Screen Settings Ⅲ COMMUNICATION menu screen • MODE item: Set to DUPLEX • STYLE item: Set to MULTIDROP • ID item: Set the camera ID. For each camera, match the ID with the VIDEO INPUT number of the RMP2580. * Settings on the COMMUNICATION menu screen are performed using the operation buttons on the front section of the camera. MEMO Following selection of MEMORY, the settings on the COMMUNICATION menu will not be valid before the power has been turned on again. Ⅲ FUNCTION menu screen Screen for making settings related to the Auto Patrol and Auto Pan functions and display of text. 14 • Settings on the FUNCTION menu are performed using the operation buttons on the RM-P2580. They cannot be made using the operation buttons on the camera body. • Make settings on other menus as required. MEMO When operating a system using the RMP2580, several cameras (up to 16) can be connected and used on one control signal cable. Consequently, an incorrect switch setting on just a single camera will cause the entire system to work incorrectly. • Confirm switch settings on the screen as follows. q Confirm that the image from the camera to be checked is displayed on the monitor. w Turn OFF and then ON the power to the camera to be checked. e When the STYLE item is MULTIDROP, characters similar to those shown in the figure below are displayed for about 5 seconds. They do not appear in the case of POINT to POINT. r Confirm that "DUPLEX" and "ID-MM" are displayed and that the ID number is the correct number (the number should be the same as the number of the VIDEO INPUT terminal to which the camera is connected on the rear panel of the RM-P2580). t If wrong, set the MODE item, STYLE item and camera ID again. MONITOR screen Monitor screen (example showing camera ID as "05") PROTO CO L : DUP L E X I D - 0 5 "DUPLEX" should be displayed. The number shown in the MM part of IDMMshould be correct.