Jenn-Air JGS8850CDS Installation Instruction - Page 16

To Convert Surface Burners 1. If installed, remove the burner grates. 2. Remove the burner caps. 3. Using a Phillips screwdriver, remove the burner base. A C B D LP Gas Orifice Spud Chart for Model JGS8750 Location Burner Rating Color Right Front 14,000 BTU Red Right Rear 9,100 BTU Clear Left Front 9,100 BTU Clear Left Rear 4,000 BTU Blue Number 114L 91L 91L 64L 5. Replace the Natural gas orifice spud with the correct LP gas orifice spud. See the "LP Gas Orifice Spud Chart." On dual burners (on some models), replace the center and outer spuds. 6. Replace burner base and hand tighten the screws. 7. Place LP burner choke into outer hole of dual burner (on some models). A. Burner cap C. Burner base screws A B. Gas tube opening D. Burner base 4. Apply masking tape to the end of a 7 mm) nut driver to help hold the Natural gas orifice spud in the nut driver while changing it. Press nut driver down onto the Natural gas orifice spud and remove by turning it counterclockwise and lifting out. Set Natural gas orifice spud aside. A B C A. Natural gas orifice spud B. Dual burner C. Single burner Use the following chart for correct LP gas orifice spud for each burner. Refer to the gas information plate on the lower left side of the front frame for proper sizing of LP gas orifice spuds for each burner location. LP Gas Orifice Spud Chart for Models JGS8850 and JGS8860 Location Burner Rating Color Number Right Front 14,000 BTU Red 114L Right Rear 4,000 BTU Blue 64L Left Front 13,000 BTU Center: White Center: 55L Outer: Orange Outer: 97L Left Rear 9,100 BTU Clear 91L A. LP burner choke 8. Replace burner cap. 9. Repeat steps 1 through 8 for the remaining burners. 10. Place Natural gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 11. Replace burner grates. 12. Reinstall storage drawer. See the "Replace Oven Racks and Storage Drawer or Warming Drawer" section for instructions. 13. Reinstall oven door. See the "Oven Door" section of the Use and Care Guide. 14. Complete installation. See "Make Gas Connection" and "Electronic Ignition System" sections. Checking for proper cooktop burner flame is very important. The small inner cone should have a very distinct blue flame ¼" to ½" long. The outer cone is not as distinct as the inner cone. LP gas flames have a slightly yellow tip. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. 16