Jenn-Air JGS8850CDS Installation Instruction - Page 4
Mobile Home - Additional Installation Requirements, Product Dimensions
View all Jenn-Air JGS8850CDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
■ All openings in the wall or floor where range is to be installed must be sealed. ■ Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. ■ The floor anti-tip bracket must be installed. To install the antitip bracket shipped with the range, see "Install Anti-Tip Bracket" section. ■ Grounded electrical supply is required. See "Electrical Requirements" section. ■ Proper gas supply connection must be available. See "Gas Supply Requirements" section. ■ Contact a qualified floor covering installer to check that the floor covering can withstand at least 200°F (93°C). ■ Use an insulated pad or ¼" (0.64 cm) plywood under range if installing range over carpeting. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194°F (90°C). Mobile Home - Additional Installation Requirements The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local codes. In Canada, the installation of this range must conform with the current standards CAN/CSA-A240-latest edition, or with local codes. Mobile home installations require: ■ When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above. Product Dimensions Models JGS8750 and JGS8850 Model JGS8860 A A G B C G B C D F A. 30³⁄₄" (78.1 cm) B. 35³⁄₄" (90.8 cm) height to underside of cooktop edge with leveling legs screwed all the way in* C. Model/serial number plate (located behind the storage drawer on the right-hand side of the oven frame) E D. 29⁷⁄₈" (75.9 cm) E. Gas information plate (located behind the storage drawer on the left-hand side of the oven frame) F. 29" (73.7 cm) from handle to back of range** G. 23" (58.4 cm) countertop notch to rear of cooktop F D E A. 30⁷⁄₈" (78.4 cm) B. 35³⁄₄" (90.8 cm) height to underside of cooktop edge with leveling legs screwed all the way in* C. Model/serial number plate (located behind the storage drawer on the right-hand side of the oven frame) D. 29⁷⁄₈" (75.9 cm) E. Gas information plate (located behind the storage drawer on the left-hand side of the oven frame) F. 29" (73.7 cm) from handle to back of range** G. 27" (68.6 cm) from handle to rear of cooktop *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. **When installed in a 24" (61.0 cm) base cabinet with 25" (63.5 cm) countertop; front of oven door protrudes 5" (12.7 cm) beyond 24" (61.0 cm) base cabinet. 4