Jenn-Air JGS8850CDS Installation Instruction - Page 17

WARNING Natural Gas Conversion 5. Lift up and remove oven bake burner cover. 6. Remove the 2 oven bake burner screws and set aside. 7. Swing the oven bake burner to the side and lift it off the oven orifice and set aside. A Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Turn manual shutoff valve to the closed position. B A C A. To range B. Shutoff valve (closed position) C. Gas supply line 2. Unplug range or disconnect power. To Convert Gas Pressure Regulator 1. Remove oven racks from inside the oven cavity. 2. Remove the storage drawer. See "Replace Oven Racks and Storage Drawer or Warming Drawer" section. 3. Remove the oven door. See "Oven Door" section in the Use and Care Guide for oven door removal instructions. 4. Using a Phillips screwdriver, remove the 2 oven bake burner cover screws located at the rear of the oven. B A A. Oven bake burner screws B. Oven orifice 8. Locate the access panel at the rear of the storage drawer compartment. Using a ¼" (6 mm) nut driver, unscrew the 2 access panel screws. Remove access panel and set aside along with the 2 screws. A A. Access panel screws 9. Locate gas pressure regulator at the rear of the storage drawer compartment. 2 A B IMPORTANT: Do not remove the gas pressure regulator. A. Oven bake burner cover B. Oven bake burner cover screws 17