Jenn-Air JGS8850CDS Installation Instruction - Page 19

3. Turn the green Number .0430 LP gas oven broil burner orifice hood counterclockwise to remove. 4. Using a Phillips screwdriver, remove the burner base. A C B D A A. Number .0430 LP gas oven broil burner orifice hood 4. Install the Number 52 Natural gas oven broil burner orifice hood, turning it clockwise 4 or 5 turns. Do not overtighten. 52 A A. Burner cap C. Burner base screws B. Gas tube opening D. Burner base 5. Apply masking tape to the end of a 7 mm) nut driver to help hold the LP gas orifice spud in the nut driver while changing it. Press nut driver down onto the LP gas orifice spud and remove by turning it counterclockwise and lifting out. Set the LP gas orifice spud aside. A. Number 52 Natural gas oven broil burner orifice hood 5. Place the oven broil burner on the oven broil burner orifice hood. Insert the oven broil burner locator pin in the hole in the oven back. 6. Position the oven broil burner against the roof of the oven cavity and attach with screw. AB C D A B C A. Natural gas orifice spud B. Dual burner C. Single burner Use the following chart for correct Natural gas orifice spud for each burner. Refer to the gas information plate on the lower left side of the front frame for proper sizing of Natural orifice spuds for each burner location. Natural Gas Orifice Spud Chart for Models JGS8850 and JGS8860 Location Burner Rating Color Number Right Front 16,000 BTU Clear 190N Right Rear 5,000 BTU Green 107N Left Front 15,000 BTU Center: Clear Outer: Clear Center: 80N Outer: 165N Left Rear 9,200 BTU Clear 142N A. Oven broil burner orifice hood C. Oven broil burner locator pin B. Oven broil burner D. Oven broil burner locator hole To Convert Surface Burners 1. If they are installed, remove the burner grates. 2. Remove the burner caps. 3. On models with a dual burner, remove the LP choke from the dual burner. Natural Gas Orifice Spud Chart for Model JGS8750 Location Burner Rating Color Number Right Front 16,000 BTU Clear 190L Right Rear 9,200 BTU Clear 142L Left Front 9,200 BTU Clear 142L Left Rear 5,000 BTU Green 107L 6. Replace the LP gas orifice spud with correct Natural gas orifice spud. See the "Natural Gas Orifice Spud Chart." 7. Replace burner base and hand tighten the screws. 19