Jensen MCD9424RC Operation Manual - Page 14

® MCD 9424JA  Testing Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly. Reconnect Battery Test Memory Wiring When wiring is complete, reconnect the battery negative terminal. - + 1 W1 1 1. With the radio playing, hold button 1 for five seconds. The radio will 5 Sec beep. You just stored the current station in memory. 2 2. Turn the key off, then turn the key on again. Test Power Wiring 1. Turn ignition switch on. The display should 3 light. If not, check the electrical connection at the yellow and red wires. 3. Press or . The radio will select a different station. 2. Press PWR to turn the radio on. You will see the radio display. If not, check electrical connections to the red and yellow wires. 4 W1 1 4. Press button 1 again. It should return to the station that was playing before (step 1). If not, make sure the yellow wire is connected properly. Test Antenna Connection 1 1. Press or . The radio should tune to a nearby station. If not, check antenna con- nection. 2 VOL 2. Press VOL to increase volume until you can hear the radio playing. Set the Clock 1 DISP 3 Sec 2 3 Sec 01 2 3 1. Press and hold DISP button for 3 seconds until display flashes. 2. Within 3 seconds, press to change minutes, to change hours. MH 5