Jensen MCD9424RC Operation Manual - Page 15
Test Speaker Connections, Balance, Fader - wiring
UPC - 043258014030
View all Jensen MCD9424RC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
® MCD 9424JA Test Speaker Connections These tests make sure the speakers are connected right. If speakers don't play at all, both wires may not be connected. If the wrong speaker plays (you hear front speakers when you expect rear speakers) make sure you connected the wires right. Balance Fader 1 SEL/ 2 VOL 1. Press SEL four times. 2. Hold the VOL button until the display shows BAL.R 15. Only the right speakers should be playing. If not, check the wiring. Make sure you connected the wires just like the chart on page 6. 5 SEL/ 6 VOL 5. Press SEL five times. 6. Hold the VOL button until the display shows FAD.R 15. Only the rear speakers should be playing. If not, check the wiring. Make sure you connected the wires just like the chart on page 6. 3 SEL/ 4 VOL 3. Press SEL four times again. 4. Hold the VOL button until the display shows BAL.L 15. Only the left speakers should be playing. If not, check the wiring. Make sure you connected the wires just like the chart on page 6. 7 SEL/ 8 VOL 7. Press SEL five times again. 8. Hold the VOL button until the display shows FAD.F 15. Only the front speakers should be playing. If not, check the wiring. Make sure you connected the wires just like the chart on page 6. Once everything is operating correctly, perform final installation described on page 7. 6