Kenmore 2029915 Use and Care Manual - Page 14

STAIR GRIP During normal operation while the canister is in the horizontal position, the caster wheel freely 360°, In o r to prevent the nister from 1stairs, the _GRIP feat ally locks the wheel in posi can ,hen the raised 25= _odzontal to V, _osition. ELECTRONIC SUCTION CONTROL The electronic suction control allows you to change the power of the vacuum cleaner suction motor Increase Suction .I Decrease Suction 1 LOW POWER decreases suction for draperies and lightweight rugs_ HIGH increases suction for upholsteries and carpets_ Wl LIGHT This vacuum cfeaner is MECHANICAL SUCTION CONTROL equipped with a light on the extension wand. This light wil! operate only when the vacuum cleaner is in The mechanical suction control allows you to adjust the vacuum suction for very light fabrics, CARPET mode (see HOW TO START). The light will operate when attached or not attached to the PowerMate The light can be used for lighting hard to reach locations Opening the control decreases suction white closing the control increases suction. Suction THERMAL PROTECTOR Suction CHECK BAG INDICATOR This vacuum cleaner has a thermal When the vacuum CHECKBAG protector which automaticalfy trips to protect cleaner is running Indicator_ __ the vacuum cleaner from overheating, If a with normal airflow, theC.ECKBAG _._" Hog prevents the normal flow of air to the !'Q-Z.q-.. ;. m_otor,the thermal protector turns the light is off,, The ./" "_. -- motor off automatically, This allows the light comes on // _ _ motor to cool in order to prevent possible whenever the /// f.._. /, damage to the vacuum cleaner,. airflobwecomes _I! I_ "_'_t \ blocked. If that 9_rs, fifskF.heck the ''_'- disposable dus[_o'ag., Then check the motor safety _ilterand other possible/.// clog Iocations_s_hown in REMOVING" CLOGS.. To correct problem: See the TROUBLESHOOTING table,, OcuOrrect problem: Tum off and unplug um cleaner to allow the vacuum cleaner to cool and the thermal protector to reset., Check for and remove clogs, if necessap.,-t,Also check and replace any clogged filters,, Wait approximately thirty (30) minutes and plug the vacuum cleaner in and turn back on to see if the motor protector has reseL NOTE: The light may come on when using certain attachments, due to reduced airi]ow through attachment, t4