Kenmore 2029915 Use and Care Manual - Page 22

I DIRT SENSOR Although the dirt sensor feature in your Kenmore PowerMate_ is designed for years of trouble free use, the passage of dirt through the air passage system can coat the lenses causing the green light to come on and stay on - never switching to red. When this happens the lenses must be cleaned, 2. As indicated by the illustration, the two dirt sensor elements are located on the inside of the swivel, approximately 3'½ inchest90 mm down, (note the arrows),, Each element should be cleaned periodically To reach the sensor elements, use a small brush such as a bottle brush, Brush each sensor element several times to remove dust and dirt , CAUTION Never use water or any cleaning solution when cleaning the lenses. The residue of the water or cleaners will accelerate the recoating of the lenses and make cleaning necessary sooner. TO CLEAN THE LENSES 1oRemove the wand from the PowerMate by pressing the quick release pedal and lifting up on the wand, _._-_ !1t Wand Quick Release Pedal Cross Section View Ap_prox., 3 ½ inches or 90 rnm . Ring i _Sensor Elements NOTE: Looking down inside the swivel you will see a ring.,The sensor elements are located just slightly below this r_ng,, 3. Reinstall the wand after cleaning the sensors. 22