Kenmore 2029915 Use and Care Manual - Page 24
See Belt Changing
View all Kenmore 2029915 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Review this table to find do-it-yourself solutions for minor performance problems, Any other service needed should be performed by a Sears or other qualified service agent WARNING Always turn off and unplug vacuum cleaner before performing maintenance to the vacuum cleaner. Failure to do so could result in electrical shock or personal injury° Vacuum cleaner won't starL t,, Unplugged at wall outlet 2., Tripped circuitbreaker/blown fuse at householdservice panel, 3. Loose hose electrical connections 1o Plug in firmly, push ON/OFF switch to on 2. Reset circuit breaker or replace fuse 3, Reconnect hose ends,, Poor job of dirt pick-up,, to Full or clogged dust bag 2_ Clogged airflow passages. 3o Dirty fillers. 4_ Wrong p_leheight setting. 5. Wrong power level selected 6_ Hole in hose. 7o Worn PowerMata agitator 8o Worn or broken belt 9. Dirty agitator or end caps. Canister hood open ti,. Tripped overload protectorin PewerMate Change bag 2. Clear airflow passages 3, Change fillers,, 4, Adjust setting 5, Adjust control 6- Replace hose. 7. Change agitator. 8&9. See BELT CHANGING AND AGITATOR CLEANING 10. Close and talch hood 11. Remove any items lhat may be caught or jammed, lhen reset If vacuum cleaner starts and stops again, clean agitator and end caps, then reset, Vacuum cleaner starts but shuts off. 1. Hose orhood electrical connections, 2. Tripped overload protectorin PowerMate 3. Tripped thermal protector in canister. 1,, Check connections, reconnect hose ends 2o Remove any items that may be caught or jammed, then reset If vacuum cleaner starts and stops again, clean agitatorand end caps, then reset. 3,, See PERFORMANCE FEATURES "Thermal Prolector" PowerMate will not run when attached° 1. PowerMate connections unplugged, 2. Worn or broken bell:, 3_ Didy agitator or end caps 4,, Tripped overload protectorin PowerMate 5. Switch not in CARPET posilion, I,, Plug in firmly 2 & 3. See BELT CHANGING AND AGITATOR CLEANING,, 4. Remove any items that may be caught or jammed, then reset If vacuum cleaner starts and stops again, clean agitator and end caps, lhen reset, 5. Move switch to CARPET position, 24