Kenmore 7540 Use and Care Guide - Page 27

General Care & Cleaning (cont'd) To Remove and Replace Oven Door Removing the Oven Door The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down. The oven door can be removed to make oven cleaning easier. To Remove Oven Door: 1. Open door approximately 4 inches to the stop position. 2. Grasp door at side edges. 3. Lift door up and off hinges. 4. To clean oven door, see the cleaning chart on page 24. To Replace Oven Door: 1. Be sure the hinge arms are in the stop position. Be careful if pulling the hinges open by hand. The hinges may snap back against the oven frame and could pinch fingers. 2. Hold the door at the sides near the top. 3. Slide the door down onto the hinges as far as it will go and close the door. 4. If the door is not in line with the oven frame, remove door and repeat the above steps. To Remove and Replace Oven Bottom !!!U! II!!III!' !II,IIIII To Remove the Oven Bottom: Grasp the oven bottom by the front corner on each side, slide toward you and lift up the oven bottom. !!i_i i!i;i_,'i'i_,i To Replace the Oven Bottom: Grasp the oven bottom and position the back tabs in place in the slots at the rear of the oven. Lower the front of the oven bottom and slide into place. _,i_iiiiiiiii_ii/_ ili.i.i.i.. _2iii% Storage Drawer Use the storage drawer for storing cooking utensils. The drawer can be removed to facilitate cleaning under the range. Use care when handling the drawer. To open the storage drawer, push the drawer in gently and it will spring open.To close, push the drawer until you hear a click, which indicates that the spring is compressed, and the drawer is closed. To Remove the Storage Drawer: 1. Open and empty the drawer of all utensils. 2. Pull drawer out to the drawer stop. 3. Lift the front high enough to allow the drawer to be pulled out. To Replace the Storage Drawer: 1. Insert the rear end of the drawer into the opening. 2. Fit the end rollers onto the guide rails. 3. Hold the drawer in a horizontal position, then push in until a click is heard. Flammable materials should not be stored in an oven, near surface elements or in the storage drawer or compartment (if equipped). This includes paper, plastic and cloth items, such as cookbooks, plasticware and towels, as well as flammable liquids. Do not store explosives, such as aerosol cans, on or near the range. Flammable materials may explode and result in fire or property damage. Grasp the oven bottom by the front corner on each side to raise and lower the oven bottom. Storage Drawer Front Frame Changing Oven Light Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life. The interior oven light will turn on automatically when the oven is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE. To Replace the Light Bulb: BE SURE OVEN IS COOL t. Turn the power off at the main source. 2. Wear a leather-faced glove for protection against possible broken glass. E3.lecRtreopnlaicceObvuelnb cwoitnhtroal.40ThWeatotvaepnplliigahntcebublbulibs ocnolvye. red with a glass shield held in place by a wire 4. Press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield. 27