Kenmore 7540 Use and Care Guide - Page 7

Grounding instructions For personal safety, the cooktop must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded. DO NOT Operate the cooktop using a 2-prong adapter or an extension cord. If a 2-prong wall receptacle is the only available outlet, it is the personal responsibility of the consumer to have it replaced with a properly grounded 3-prong wall receptacle installed by a qualified electrician. See the INSTALLATION INSTRUCTIONS packaged with this range for complete installation and grounding instructions. Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. Power supply cord with 3-prong grounding plug This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and should be plugged directlyintoa properlygrounded receptacle. DO NOTcut or removethe grounding prong from this plug. Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician. _Avoid fire hazard or electrical shock. DO NOT use an adapter plug, an extension cord, or remove g rounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death. Conversion to Liquefied Petroleum Gas (or L. P. Gas) This natural gas range is designed to allow for conversion to Liquefied Petroleum (L. P.) Gas. Only a qualified service agent should perform the L. P. conversion. Call I=800=4=IVIY=HOME® if you wish to have To avoid serious injury, any additions, changes or conversions required in order for this appliance /_ to satisfactorily meet the application needs must be made by a qualified service agent. Sears Service perform the conversion. An L. P. Conversion Kit is provided with this range and is located on the main back of the range. The kit contains installation instructions which must be read before and followed carefully when installing the kit.