Kenmore 7540 Use and Care Guide - Page 9
Before Setting, Surface, Controls
View all Kenmore 7540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Before Setting Surface Controls Assembly of the Surface Burner Heads, Burner Caps and Burner Grates It is very important to make sure that all of the Surface Burner Heads, Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Remove all packing tape from cooktop. Remove Burner Caps and Burner Heads. 2. Discard all packing material located under all Burner Heads. 3. To replace Burner Heads & Caps, match the letters located under center of Burner Caps with the letters located inside Burner Head (See Figure 2). 4. Match the letters stamped on Burner skirts with Burner Heads and Burner Caps on cooktop (See Figure 2). Carefully align the Electrodes into slots or holes of the Burner Heads (Figure 1). Note: The Burner Heads should sit flat on Cooktop Burner Skirts. 5. Unpack Burner Grates and position on cooktop. REMEMBER-- DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. must align into slot or hole for each Burner Head Figure 1 _BUpe_ ....... Figure 2 Locations of the Gas Surface Burners The SIMMER burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop. The STANDARD sized burners are used for most surface cooking needs. These burners are located at the left rear and center positions on the cooktop. The POWER burners are best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. These burners are located at the right front and left front positions on the cooktop. Figure 3