Kenmore 9742 Use and Care Guide - Page 38
Changing, the Oven, Cleaning, of Stainless, Steel, models
View all Kenmore 9742 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
General Care & Cleaning • Changing the Oven Light(s) Oven Light Wire Holder Changing the Oven Light (s) The oven light(s) automatically turn ON when the oven door is opened. The oven light(s) may also be manually operated by pressing the _ pad. The oven light bulb(s) are located at the rear of the oven and covered with a glass shield held by a wire holder. The glass shield(s) must be in place whenever the oven is in use. To replace the oven light bulb: 1. Turn electrical power off at the main source or unplug the range. 2. Press wire holder to one side to release the glass shield. 3. Replace bulb with a new 40 watt appliance bulb. 4. Replace glass shield over bulb and snap wire holder into place. 5. Turn power back on again at the main source (or plug the range back in). 6. The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Guide. Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass. Care and Cleaning of Stainless Steel (some models) Some models are equipped with stainless steel exterior parts. Special care and cleaning are required for maintaining the appearance of stainless parts. Refer to the Care & Cleaning Table for detailed cleaning instructions. 38