Kenmore 9746 Use and Care Guide - Page 31

Fie× Clean To set a Flex Clean to start immediately (cont'd): As soon as the controls are set, the motor driven door lock will begin to close automatically. "door Lot" will appear in the display (See Fig. 1). DO NOT open the oven door while "door Loc" is displayed (allow 15 seconds for the oven door to completely lock). Once the door has locked "CLn" will appear in the display indicating the oven will begin the self-clean process(Fig.2). Setting delayed start Flex Clean cycle Example: To start a delay Flex Clean with a default clean time of 3 hours and a start time of 9:00 o'clock: Step Press 1. Be sure the clock is set with the correct time of day, ALL the oven racks are removed and the oven door is closed. 2. Press Delay Start. 3. Enter 900 for time to start. \s,,_/ ®@@ Fig. 1 Fig. 2 When the Flex Clean cycle has completed: , The time of day and "Hot" will appear in the display window (See Fig.3). 2. Once the oven has cooled down for about I hour and "Hot" is no longer displayed the "door OPn" message should appear (Fig. 4). When this message turns off the oven door may be opened. Use CAUTION and avoid possible burns when opening the door after the selfcleaning cycle has completed. The oven may still be VERY HOT. When the oven is cool, wipe away any residue or powdered ash with a damp cloth or paper towel. 4. Press Start. 5. Press Flex Clean. 6. Press Start. A ctoo. v iiii To avoid possible burns use care when opening the oven door after the self-clean cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape. DO NOT force the oven door open. This can damage the automatic door locking system. Use CAUTION and avoid possible burns when opening the door after the Flex Clean cycle has completed. The oven may still be VERY NOT. Fig. 3 Fig. 4- If it becomes necessary to stop a Flex Clean cycle once it has been activated: 1. Press Stop/Clear. 2. If the self-clean cycle has heated the oven to a high temperature, allow enough time for the oven to cool and for the "door OPn" message to appear (Fig. 4). When this message turns OFF the oven door may be opened. 3. Restart the Flex Clean cycle once all conditions have been corrected. Whenever the Flex Clean feature is active you may check the amount of time remaining in the cycle by pressing the Flex Clean pad once. The oven door will be locked until the range has cooled sufficiently. You should allow about 1 additional hour to the time displayed before you can open the oven door. The Flex Clean feature will not operate whenever a surface element is turned ON. Flex Clean may be started if the Cooktop Lockout feature is active. A Flex Clean cycle cannot be started if the Oven Lockout feature is active. If a Flex Clean cycle was started and a power failure occurs, the oven may not be thourghly cleaned. Once _ower is restored, set self-clean again to finish. 31