Kenmore MS-1242KLSY Use and Care Guide - Page 34

rinse and wipe dry. Avoid hitting or bending the metal stirrer blade, as this could cause uneven

Get Kenmore MS-1242KLSY - 1.2 cu. Ft. Countertop Microwave PDF manuals and user guides View all Kenmore MS-1242KLSY manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

• Stirrer shield The oven insidetop (stirrer shteid)can be gently wiped in place or removed for washing at the sinkl Excessiveoil spatterson the inside top (stirrer shield) will make them difficultto remove, if left for many days. Wipe them with a wet paper towel especially after cooking chicken or bacon. The stirrer shield sets in slots along the sides and in the rear of the oven and is held by three tabs in front. Carefully pull the front edge down and forward to remove. Wash only in warm [not hot) detergent water, rinse and wipe dry. Avoid hitting or bending the metal stirrer blade, as this could cause uneven cooking or mlcrowave power loss. To replace shield, slide it into the side and rear slots with cut-off at left rear comer. and carefully fit the front edge of the shield with three tabs. • Exhaust filters The two mesh exhaust filters on the hood bottom cover can be removed for washing in a sink. The filters are held by metal springs in the center of the hood bottom cover. To remove it, place a finger in the finger recess of the hood bottom cover and push it toward the center and pull down. Wash only in warm detergent water, rinse and wipe dry. Do not use ammonia for aluminum mesh fillers. Do nol run the hood fan without the filters. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
•
Stirrer
shield
The
oven
inside
top (stirrer
shteid)can
be gently wiped
in
place or removed for washing at the
sinkl
Excessive
oil spatterson
the
inside
top (stirrer
shield)
will
make them difficult
to remove,
if
left for
many
days.
Wipe them with a wet paper towel especially after cooking chicken or bacon.
The stirrer shield sets in slots along the sides and in the rear of the oven and is held by three tabs in front.
Carefully pull the front edge down and forward to remove. Wash only in warm [not hot) detergent water,
rinse and wipe dry. Avoid hitting or bending the metal stirrer blade, as this could cause uneven cooking or
mlcrowave power loss. To replace shield, slide it into the side and rear slots with cut-off at left rear comer.
and carefully fit the front edge of the shield with three tabs.
•
Exhaust
filters
The two mesh exhaust
filters on the hood
bottom
cover can be removed
for washing
in
a sink.
The
filters
are held
by metal
springs
in the
center
of the hood
bottom
cover.
To remove
it, place
a finger
in the finger
recess of the
hood
bottom
cover
and push it toward
the center
and pull down.
Wash
only
in
warm
detergent
water,
rinse
and wipe
dry.
Do
not use ammonia
for aluminum
mesh
fillers.
Do
nol run the hood
fan without
the filters.
34