Kenwood DDX616 Instruction Manual - Page 102
Accessories, Installation Procedure - wiring installation
UPC - 019048186867
View all Kenwood DDX616 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Accessories Installation Procedure .......... 1 .......... 1 ® .......... 1 ..........2 1. To prevent a short circuit, remove the key from the ignition and disconnect the 8 battery. 2. Make the proper input and output wire connections for each unit 3. Connect the speaker wires of the wiring harness. 4. Connect the wiring harness wires in the following order: ground. battery, ignition. 5. Connect the wiring harness connector to the unit 6. Install the unit in your car. 7. Reconnect the 8 battery. 8. Press the reset button. 9. Perform the Initial Setup. (Refer to the Instruction Manual.) DNX SERIES only .......... 1 .......... 1 DNX SERIES only .......... 1 1 ® *'Accessory of DNX69601 DNX61601 DNX6020EXI DNX6460BTI DDX6161 DDX6046BT *JAccessory of DNX69601 D X61601 DNX6020EXI DNX5160. tThis accessory is used when connecting an external device to AV-IN jack on the front panel of this unit For how to use this accessory. refer to the instruction manual of this unit ..........6 AWARNING If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground). you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to t e wires via the fuse. Acquiring GPS Signals The first time you turn on DNX SERIES, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter. After the Installation After the installation, perform the Initial Setup by referring to the instruction manual. ..........6 ® ~ ..........2 1 I 2 DNX SERIES/ DDX SERIES