Kenwood DDX7015BT Operation Manual 1 - Page 62
Installing the unit
View all Kenwood DDX7015BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
CONNECTION/INSTALLATION R Supplied accessories for installation 1 Wiring harness x 1 2 Trim plate x 1 *1 3 Extension wire (2 m) x 1 4 Flat head screws (M5 x 7 mm) x 6 *2 5 Round head screws (M5 x 6 mm) x 6 6 Steering Remote cable x 1 7 Microphone (3 m) x 1 8 Fixture for HDMI/MHL connector x 1 9 Screws for fixture (M2.6 x 6 mm) x 1 0 Film antenna x 1 *3 - Amplifier unit (cable with booster, 3.5 m) x 1 *3 = Cable clampers x 3 *3 ~ Cleaner x 1 *3 *1 Only for DDX7015BT Region 4/DDX5015BT/DDX5015DAB. *2 Only for DDX7015BT/DDX7015BTM/DDX5015DAB/DDX5015BT/ DDX515BT/DDX515BTM. *3 Only for DDX5015DAB. R Installation procedure 1 To prevent a short circuit, remove the key from the ignition and disconnect the · battery. 2 Make the proper input and output wire connections for each unit. 3 Connect the speaker wires of the wiring harness. 4 Connect the wiring harness wires in the following order: ground, battery, ignition. 5 Connect the wiring harness connector to the unit. 6 Install the unit in your car. • Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). 7 Reconnect the · battery. 8 Press the reset button. 9 Configure . (Page 4) Installing the unit R Installing the unit using the mounting bracket removed from the car 4 or 5 Car Bracket 4 or 5 • Select the appropriate type of screw for the mounting bracket: flat head (4) or round head (5). R Installing the trim plate (Only for DDX7015BT Region 4/DDX5015BT/ DDX5015DAB) 1 Attach the trim plate (2). 2 62