Kenwood DRV-410 Operation Manual - Page 14
How to Wire - dashboard camera
View all Kenwood DRV-410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
How to Wire Power cord for Dashboard Camera (accessory) CAUTION Before performing the connection work, first check that the engine key is removed and then be sure to disconnect the negative terminal of the battery to prevent a short accident. Connect the Dashboard Camera and power cord. Dashboard Camera Cord length (3.5 m) Ignition key switch Fuse Accessory power supply Accessory cord (Red) Connect to a power supply that can be turned on and off with the switch. ACC Fuse (2 A) Main fuse BATT Battery cord (Yellow) Connect to a power supply with a voltage always applied regardless of whether or not the engine key is on or off at a point after the power has passed through the main fuse. Battery Ground cord (Black) Connect to a metal part of the vehicle (part of the chassis with an electrical GND connection to the negative side of the power supply). 10