Kenwood KCA-BT300 Instruction Manual - Page 32
Accessories/ Installation Procedure - kab wire
View all Kenwood KCA-BT300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Accessories/ Installation Procedure Accessories 1 3 3 m (9.5 ft) ..........1 2 4 ..........2 ..........1 ..........1 Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Set the Type switch. 3. Make the proper input and output wire connections for each unit. 4. Install the unit in your car. 5. Reconnect the - battery. 6. Press the reset button on the control unit. ¤ • Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. • After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly. For Good Reception To assure good reception, note the following: • Communicate with the cell-phone within the lineof-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment. The communication range also becomes shorter when there is an obstacle between this unit and the cell-phone. The above maximum communication range (10 m) is not always assured. • Keep this unit away from other electric components (AV components) as far as possible. If they are near, call connection can fail, TV or radio noise can be generated, or poor reception can occur. • A broadcast station or walkie-talkie located nearby can interfere with communication due to too strong signal. Setting the Type Switch Set the Type switch according to the type of the control unit connected. See the Type switch setting column of the model list (page 4). For the models released after April 2010, set the Type switch as follows. - For the model connected with the 5L connector 1: OFF, 2: OFF, 3: OFF - For the model connected with the KAB connector 1: OFF, 2: ON, 3: OFF - For more details, see the following web site. Set the Type switch according to the web site when the above setting is different from that of the web site. www.kenwood.com/cs/ce/bt/ OFF 123 ON 1: Display Character Conversion Function When the control unit cannot display accent characters ("u", "a", etc.), it converts these characters to upper-case alphabetic characters. OFF: Do not covert characters. ON: Convert characters. 2: Specifying the Connector to Connect Specify the type of the connector to be connected to the control unit. OFF: Use the 5L connector. ON: Use the KAB connector. 3: Specifying the Control Unit Type Specify the type of the control unit to connect to. OFF: Set when no control unit type is specified in Model list, or the control unit type is not in the model list. ON: Set when the control unit type is specified in Model list. 32 | KCA-BT300