Kenwood KCA-BT300 Instruction Manual - Page 34
Troubleshooting Guide, Installation - problem
View all Kenwood KCA-BT300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Installation Troubleshooting Guide Installation of the Bluetooth unit ¤ • Determine the installation position after making sure that the unit can communicate with the Bluetooth device. • Please do not install the unit near the dashboard, the rear tray, or other important components. Doing so could lead to injury or accident should the unit come off due to a shock and strike a person or an important component. Tapping screws should be used for mounting. (Attachment with velcro strips, although easy, can come off with a shock.) Securing to audio board Accessory 2 (Ø4 × 16 mm) Antenna part Securing to pile carpet Antenna part Accessory 3 ⁄ • Do not stick the velcro tape over the serial number. • If the installation place is stepped, cut the velcro tape into two pieces and stick them at two positions. What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. ? The hands-free talk volume is low. ✔ The hands-free talk volume is set at a low level. ☞ The hands-free talk volume can be adjusted independently. Adjust it during hands-free talk. ? No sound is heard from the rear speakers. ✔ You are talking in the hand-free talk mode. ☞ No sound is heard from the rear speakers in the hands-free talk mode. ? No beep is heard at reception of an incoming call. ✔ No beep is heard depending on the type of your cell-phone. ☞ The is set ON. ? Voice is not recognized. ✔ The vehicle window is open. ☞ If the surrounding noise is large, voice cannot be recognized properly. Close the vehicle windows to reduce noise. ✔ Small voice. ☞ If voice is too small, it cannot be recognized properly. Speak into the microphone a little more loudly and naturally. ✔ The person uttering the voice tag is not the one who registered the it. ☞ Only the voice of the person who registered the voice tag can be recognized. ? The Bluetooth audio player cannot be registered (pairing). ✔ The PIN code is fixed. ☞ When a PIN code is specified in the Instruction Manual for Bluetooth Audio Player, register it with reference to to register the Bluetooth audio player. If no PIN code is specified in the Instruction Manual, try "0000". ? The sound from the Bluetooth audio player is discontinuous. ✔ The distance between this unit and audio player is too far. ☞ Move the audio player nearer to this unit. ✔ Another Bluetooth device is affecting the Bluetooth communication. ☞ Turn off another Bluetooth device. ☞ Move another Bluetooth device away from this unit. The messages shown below display your systems condition. No Number/ NO-NMBER/ Incoming No Number : • The calling party does not notify a caller ID. • There is no phone number data. 34 | KCA-BT300