Kodak BC4601 Service Manual - Page 14

SERVICE MANUAL Replacing the AUTO-FOCUS BRACKET ASSEMBLY Warning Dangerous Voltage [1] Disconnect the main power. [2] Do the replacement procedure for the LOWER HOUSING ASSEMBLY. [3] Cut and remove the necessary WIRE TIES. [4] Disconnect the 2 wires from the CYCLE SOLENOID on the SMALL CIRCUIT BOARD. [5] Pull the SMALL CIRCUIT BOARD up. [6] Do the replacement procedure for the MECHANISM ASSEMBLY. [7] Remove the Torx SCREW from the WORM PULLEY. [8] Remove the WORM PULLEY. [9] Remove the 2 Hex SCREWS from the CYCLE SOLENOID. [10] Remove the CYCLE SOLENOID. [11] Remove the Phillips SCREW from the AUTO-FOCUS BRACKET ASSEMBLY. [12] Pull and remove the AUTO-FOCUS BRACKET ASSEMBLY through the hole where the CYCLE SOLENOID was. SCREW SCREW (2) WORM PULLEY CYCLE SOLENOID AUTO FOCUS BRACKET ASSEMBLY SCREW A091_4023BCA A091_4023BA Installing the AUTO-FOCUS BRACKET ASSEMBLY [1] Do the replacement procedure for the AUTO-FOCUS BRACKET ASSEMBLY in reverse order. Replacing the CAM STACK ASSEMBLY and CYCLE LEVER ASSEMBLY Warning Dangerous Voltage [1] Disconnect the main power. [2] Do the replacement procedure for the MECHANISM ASSEMBLY. [3] Remove the INDEXER LEVER ASSEMBLY from the TOP PLATE of the MECHANISM ASSEMBLY. [4] Remove the Torx SCREW from the WORM PULLEY ASSEMBLY. [5] Remove the WORM PULLEY ASSEMBLY. [6] Remove the DIRECTION LEVER LINK from the DIRECTION LEVER. 14 18NOV97 - SM5440-1