Kodak BC4601 Service Manual - Page 26

SERVICE MANUAL Adjustment Specification This adjustment adjusts the strobe and timing of the INDEXER LEVER. The gate edge of the black plastic of the INDEXER LEVER should be between the 2 holes at position 2. Adjusting the INDEXER LEVER ASSEMBLY Warning Dangerous Voltage [1] Disconnect the main power. [2] Do the removal for the MECHANISM ASSEMBLY. [3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE. [4] Check the alignment of the INDEXER LEVER with the hole in the TOP PLATE ASSEMBLY at Position 1. [5] Bend the INDEXER LEVER to the correct position. [6] Check the travel of the INDEXER LEVER in the FORWARD position. When the INDEXER LEVER moves in the FORWARD position, the gate edge of the black plastic should be between the 2 holes at Position 2. [7] Bend the INDEXER LEVER until you reach the correct position. MECHANISM ASSEMBLY TOP PLATE Bend here. MECHANISM RUNNING FIXTURE position 1 position 2 A091_0008HCA A091_0008HA Adjustment Specification Use a MECHANISM RUNNING FIXTURE. Use TL-3001 to measure the height of the SLIDE LIFT LEVER. The LEVER should make contact with the low surface of TL-3001. The LEVER should not make contact with the high surface of TL-3001. 26 18NOV97 - SM5440-1