Konica Minolta AccurioPress C3080 IC-314 User Guide - Page 64

54 Chapter 3-Calibration ● The short form of the report shows a summary of the CMY Gray Ramp Lightness and Gray Balance Summary and a Black Ramp Lightness Summary. ● The long form of the report shows a summary of the CMY Gray Ramp Lightness and Gray Balance Summary and a Black Ramp Lightness Summary, as well as lists of the Lightness and gray balance comparison of CMY gray ramp tints, and Lightness comparison of Black ramp tints. 12. Click Print to print the report, or click Close. When printing the report, you can choose to save it as a PDF, if required. 13. Click Finish to exit the wizard. Running automatic calibration with the color and quality adjustment package The Creo server participates in the Konica Minolta Automatic Color Quality Adjustment Package procedure, which is initiated and programmed on the printer panel. Among the different color and quality adjustment processes available, a controller calibration might be enabled and performed as part of the sequence using the IQ-501 Intelligent Quality Optimizer measuring device. This type of controller calibration is automatic and does not require any user intervention or any calibration wizard programming as part of the process. Note: Currently, G7 calibration is not supported as part of the Automatic Color Quality Adjustment Package. Troubleshooting calibration Resolve common troubleshooting problems that can occur during the calibration process. Message Values collected during the measurement are not monotonous. The i1 is not calibrated. Place it on the base and click OK to proceed. Recovery action This message might appear after calibration measurements. Run the calibration procedure again, and if the problem persists, contact your service representative. Place the X-rite i1 back on its base to re‑calibrate it.