Konica Minolta KIP 79 Series KIP 79 Series Hardware User Manual - Page 57

Paper Exit Door.

Get Konica Minolta KIP 79 Series PDF manuals and user guides View all Konica Minolta KIP 79 Series manuals
Add to My Manuals
Save this manual to your list of manuals

Page 57 highlights

2. Pull and remove the mis-fed paper to the rear. If you remove the print at this time, just close the Paper Exit Door. If the print cannot be removed, go to the next step. If the print (including any torn part) can be removed, go to step 6. mis-fed paper WARNING Be careful not to get burnt when you touch the printing paper as it may be very hot. NOTE If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the next print. 4. Hold the gray areas (2) and release the Fuser Door (3). Pull and remove the mis-fed paper to the rear. 2 2 mis-fed paper 3 WARNING There are extremely hot parts inside the Fuser Door. Do not touch any parts in the Heater Unit, or you will be burnt. Also be careful not to get burnt when you touch the printing paper as it may be very hot. NOTE If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the next print. 3-10 Chapter 3 Error Correction

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
Chapter 3
Error Correction
3-10
2. Pull and remove the mis-fed paper to the rear.
If you remove the print at this time, just close the
Paper Exit Door.
If the print cannot be removed, go to the next step.
If the print (including any torn part) can be removed,
go to step 6.
4. Hold the gray areas (2) and release the Fuser Door (3).
Pull and remove the mis-fed paper to the rear.
mis-fed paper
3
2
2
mis-fed paper
WARNING
There are extremely hot parts inside the Fuser Door.
Do not touch any parts in the Heater Unit, or you will be burnt.
Also be careful not to get burnt when you touch the printing paper as it may be very hot.
NOTE
If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the
next print.
WARNING
Be careful not to get burnt when you touch the printing paper as it may be very hot.
NOTE
If removed a mis-fed paper inside the Fuser Door, scattered toner can be adhered to the
next print.