Kyocera ECOSYS M4125idn M4125idn/M4132idn Operation Guide - Page 443

Troubleshooting > Responding to Messages Responding to Messages If the touch panel or the computer displays any of these messages, follow the corresponding procedure. NOTE When contacting us, the serial number will be necessary. To check the serial number, refer to the following: Display for Device Information (3-10) A Symptom Acceptable staple count exceeded. Access point was not detected. Activation error. Add the following paper in cassette #. Add staples. Add the following paper in the multipurpose tray. Adjusting... Checkpoints Corrective Actions Reference Page Is the acceptable staple count exceeded? Select [Continue] to print without stapling. Select [Cancel] to cancel the job. - Check if the access point has been 2-15 set correctly. - Turn the power switch off and on. If 2-9 the error exists, contact administrator. Is the indicated cassette out of paper? Load paper. Select [Paper Selection] to select the other paper source. Select [Continue] to print on the paper in the currently selected paper source. 3-18 Has any of the document finisher run out of staples? If the staples are depleted, the machine will stop and the location of staple depletion will be indicated on the screen. Leave the machine on and follow the instruction to replace the staple case. Select [Continue] to print without stapling. Press [Cancel] to cancel the job. 10-10 Does the paper size set for the paper Select [Continue] to continue 5-7 source matches the paper size that was printing. actually loaded? Select [Cancel] to cancel the job. Is the indicated cassette out of paper? Load paper. Select [Paper Selection] to select the other paper source. Select [Continue] to print on the paper in the currently selected paper source. 3-18 - The machine is under the - adjustment to maintain its quality. Please wait. 11-9