Kyocera FS 720 FS-720 Operation Guide - Page 22
Connecting to Power, Connections, OPERATION GUIDE, Power Cord Connector, Power Switch
View all Kyocera FS 720 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connections Connecting to Power Install the printer close to an AC wall outlet. If an extension cord is used, the total length of the power cord plus extension should be 5 meters (16 feet) or less. NOTE: Ensure the printer's power switch is off. Only use the power cord supplied with the printer. 1 Connect the power cord to the Power Cord Connector at the rear of the printer. 2 Connect the other end of the power cord to a power outlet. 3 Press the Power Switch to On ( | ). The printer begins to warm up. IMPORTANT: If you install the Toner Container and switch on the power, the two indicators will start fast flashing. When the printer is first switched on after toner installation, there will be a delay of approximately 15 minutes before the printer gets ready to print. Once the Ready indicator lights, printer installation is complete. 10 OPERATION GUIDE