LG 42LH250H Owners Manual - Page 133
Reference, LT2002, Cloning, Procedure, Troubleshooting
View all LG 42LH250H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
Reference: LT2002 Cloning Procedure Troubleshooting Warning: Do not use LT2002 while any PPV card is installed in TV or clone programmer will be damaged. Reset Clone After Static Shock After replacing exhausted batteries, or if the programmer behaves strangely after a static shock, use a paper clip or similar instrument inserted through the small hole marked "RESET" to activate the internal reset switch and restore normal operation. After a reset, check the real-time clock setting. It may be necessary to reset the Clone Programmer clock from a TV containing the correct time. Note The LT2002 programmer is designed to be used with TVs containing the 221-01006 and later processors. Use with earlier TV sets may give unpredictable results. Processors used before the 221-01006-04 have a limited screen display capability. They cannot display entire screens as shown in the quick setup instructions accompanying the LT2002 clone programmer. Use the printed menu illustrations on the quick setup sheet supplied with the Clone as an aid to making your programming choices. (Although the menus are not all displayed, the clone functions all operate normally.) Clone Programmer Troubleshooting Problem Possible Cause(s) Clone Programmer Clone copies Setup in less than 30 seconds Remote does not operate clone. LED does not blink. Clone menu hard to read. No time set. Not enough time to copy entire TV setup. Wrong Installer remote. , M.P.I. cord not connected. , TV not turned on. , Weak batteries. Weak signal. , Time not available. Clone not working. Clone Scans Channels more than once. , Clone programmer problem. , Clone should only scan channels once. Possible Solution(s) - Press Reset on clone programmer, redo teach/learn. (Teach/Learn should take a minimum of 1 minute.) - Only use an LG Installer remote to operate clone programmer with TV. - Connect M.P.I. cord properly, assure good connection. - TV must be powered On for clone to work. - Install 4 fresh AA high-quality alkaline batteries. - Connect TV to a reliable Analog channel signal source. - Set time on a TV, copy time to Clone Programmer. - Try a different LT2002 Clone programmer. - Reset Clone Programmer. - Retry cloning again. Master and Other TVs Cloning did not work. , Procedure interrupted. , Different TV models. , Step(s) omitted or not performed. - Wait until procedure complete message is displayed. - Cloning is only possible with identical model ]Vs. - Reread pages 7-8-9 to be sure all tasks were performed. Clone time disappeared. , Batteries were removed. - Batteries must remain installed to retain time settings. New Setup not present. , TV not reset. - Disconnect newly-cloned unit from power for 5 seconds. , After cloning operations am complete, just unplug the LT2002 from the TV, , If the TV does not display a picture on the TV (blank screen) after a few seconds, just change channels, 206-4118 PA G E 2 5