LG DLG2532W Owners Manual - Page 11

IMPORTANT : InstMlation must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part 32-80 or Standa_ CAN/CSA-Z240 MH. The dryer can _ installed in a manuthctured (moNle) home by lollowing these instructions: 1. IMPORTANT : Gas drye_ MUST be permanently attached to the fl{n_rat the time of installation. 2 Elcctrical Connections (Ekctric Drycr Ordy) musl be a 4-wire connection. 3 Venting = Dryer MUST _ exhausled to the outdoors. To reduce the risk of fire and combustion gas accumulation, the dryer MUST BE EXHAUSTED TO THE OUTDOORS. Refer to _ction on Dryer Exhaust Requirements. • The dryer c_m _ exh_mstcd to the outdCx)rs through the back, left, right or bottom panel. Gas dryeJ_ cannot be exhausted out the right side bccau_ of _le bumer housing. • The d_3_er exhaust duct must be _curcd to _le mobile home structure. • Exhaust ducts MIST NOT be connected with sheet metal screws or fasteners which extend into the duct. • Exhaust dnct must not _ connected to _my other duct, vent or chimney. I)rycr exhaust duct MUST NOT tcnninme under lhe lnobik: home. For protmr olmmtion, it is im[_g}r|ant fllat file dryer has an _m_ple amount of outside Fresh ai:r. The opening liar outside air must _ at least 25 in_(1 (Gcm) O When exhzmsting the dryer to the outdoors, Ihe d:ryer can _ installed with "1" inch clearance at fl_e sides and rear. Clem'ance of the duct from combustible construction nmst b_ a minimum of 2 inches (5.08 cm). Venting nmk_als _e not supplied wifll the dryer (obtain locally). To reduce the risk of fire, the exhaust duct and weather hood MUST be fabricated of a material that will not support combustion. Rigid or flexible metal pipe is recommended for a clothes 11