LG DLG2532W Owners Manual - Page 16

Gas Dryers (120 Volt, 60 Hertz, with 3-Prong (;rounding Plug) NOTE : The wMng diagram is located inside the control panel, inside the control cabinet. To reduce the risk of fire, electric shock or _rsonal injury, all wiring and grounding MUST confirm with the latest edition of the tile National Electrical Code ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer's responsibility to have the wiring and fuses checked by a qualified electrician to make sure the laundry room has ad_uate electrical power to operate the dryer. i O The dryer is designed m _ operated on a scparate branch, pd_u_ized, lhrcc-wirc, effectively grounded, :120 Volt, 6(} Hertz, AC (alternating ctm_ent) circuit protected by a 115Amperc fuse, equivalent fusemm or circuit brcakcr. • The thre_-p:mng grounding plug on the lx)wer cord should _ plugged dh'ectly into a polarized three-slot effectively grounded receptacle rated 120 Volts AC (alternating current) 15 Amps. Refer to Figmre 22 to determine correct tx_hfity of the wall receptacle. NOTE : A qualificd electrician should chc_ck the polarity of the wall receptacles. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem. • 1>',)NOT OPERATE OTHER APPI,IANCES ON THE SAME CIRCUrI' WHEN THIS APPI_IANCE IS OPERATING. DO NOT OVERI,OAD CIRCUrI'S ! • IN) NOT operat:e both a washer and gas dwer on the vm_e ckcuit. Use separately fused 15 Amp circuits. To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source. DO NOT OVERLOAD CIRCUITS DO NOT USE AN ADAPTER DO NOT USE AN EXTENSION CORD This dryer is _uipped with a threeprong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug. 16