LG DLG2532W Owners Manual - Page 15
wire connection: Direct wire
View all LG DLG2532W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3-wire connection: Direct wire U_ where I_al c_es permit connecting cabinet-ground conductor to neutral wire, Direct wire cable must have 5 ft (1.52 m) of extra length so dryer can be moved if needed. Strip 3V2 in, (8.9 cm) of outer covering from end of cable. Strip insulation back 1 in. (2.5 cm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape ends of wires into a hook shape. When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw. %," Optional 3-wire connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 1_.Remove center terminal block screw_ 2, Remove appliance ground wire (green) from external ground connector screw, Connect appliance ground wire and the neutral wire (white or center wire) of power supply cord/cable under center, silver colored terminal block screw. Tighten screw, 3. Connect the other wires to outer terminal biock screws. Tighten screws, , °9c _r'/ 1, Loosen or remove center terminal block screw, 2, Place the hooked end of the neutral wire (white or center wh°e) of power supply cable under the center screw of terminat block (hook facing right), Squeeze hooked end together, Tighten screw, 4. Tighten strain relief screws. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6 Connect a separate copper ground wire from the external ground _nnector screw to an adequate ground. 1. External ground connector 2, Neutral grounding wire (green) 3. Center silver-colored terminal block screw 4. Neutral wire (white or center wire) 5, 3/4 in. (1.9 crn) ULqisted strain relief , Place the hooked ends of the other power supply cable wires under the outer terminal block screws (hooks facing righ9. Squeeze hooked ends together. Tighten screws. 4. Tighten strain relief screws. 5. Insert tab of terminal block _ver into slot of dryer rear panel. Secure cover with hold-down screw. 1. External ground connector 2. Neutral grounding wire (green) & Neutral w_re (white or center wire) 4. Grounding path determin_ by a qualified electrician 15