Lantronix xDirect xDirect - User Guide - Page 50
Send the Escape Sequence (+++) in Modem Mode, Show IP Address after 'RING', Table 8-10
View all Lantronix xDirect manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
8: Setup Mode: Channel Configuration The character string ATH is received, terminated with a carriage return. The unit responds affirmatively according to the selected echo/response mode and drops the network connection. The serial interface reverts to accepting command strings. If this sequence is not followed, the unit remains in data transfer mode. Modem Mode Command ATDTx.x.x.x,pppp or ATDTx.x.x.x/pppp or ATDTx.x.x.x:pppp ATDTx.x.x.x ATD0.0.0.0 ATD or ATDT ATDx.x.x.x ATH ATS0=n Table 8-10 Modem Mode Commands Function Makes a connection to an IP address (x.x.x.x) and a remote port number (pppp). Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. Forces the unit into Monitor Mode if a remote IP address and port number are defined within the unit. Forces the unit into Monitor Mode if a remote IP address and port number are not defined within the unit. Makes a connection to an IP address (x.x.x.x) and the remote port number defined within the unit. Hangs up the connection (Entered as +++ATH ). Enables or disables connections from the network going to the serial port. n=0 disables the ability to make a connection from the network to the serial port. n=1-9 enables the ability to make a connection from the network to the serial port. n>1-9 is invalid. ATEn ATVn Enables or disables character echo and responses. n=0 disables character echo and responses. n=1 enables character echo and responses. Enables numeric response or full verbose. n=0 enables numeric response. n=1 enables full verbose. Note: The unit recognizes these AT commands as single commands such as ATE0 or ATV1; it does not recognize compound commands such as ATE0V. Send the Escape Sequence (+++) in Modem Mode Send '+++' in Modem Mode (Y) ? _ Disable or enable the xDirect's ability to send the escape sequence. The default setting is Y (Yes) (send the escape sequence). Show IP Address after 'RING' Show IP addr after "RING" (Y) ? xDirect User Guide 50