Lenovo PC 300 Hardware Maintenance Manual (HMM) for Aptiva, IBM PC300, and Net - Page 95
Hard Disk Drive, Pivot the tray outward, then lift it slightly to remove
View all Lenovo PC 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Hard Disk Drive To remove or replace the hard disk drive: Make sure to disconnect the power and signal cables from the CD-ROM drive and the diskette drive. Pivot the latch that secures the lower drive-mounting tray. Slide the drive-mounting tray toward the rear of the computer and remove it. Note: If the chassis is not like the figure, please refer to the following. Press down the latch. Pivot the tray outward, then lift it slightly to remove it Remove the four screws (two on each side) that hold the hard disk drive to the mounting tray. Pull the hard disk drive from the mounting tray to remove it. 95
95
Hard Disk Drive
To remove or replace the hard disk drive:
±
Make sure to disconnect the power and signal cables from the CD-ROM drive and the diskette drive.
±
Pivot the latch that secures the lower drive-mounting tray. Slide the drive-mounting tray toward the rear of the computer
and remove it.
Note
: If the chassis is not like the figure, please refer to the following.
±
Press down the latch.
±
Pivot the tray outward, then lift it slightly to remove it
±
Remove the four screws (two on each side) that hold the hard disk drive to the mounting tray.
±
Pull the hard disk drive from the mounting tray to remove it.