Lexmark E350d Service Manual - Page 116
Printhead removal, Disconnect the cables J5 DRV A, J8 LXK LSU B, and J15 C from the controller card.
View all Lexmark E350d manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
4512-420, -430 Printhead removal 1. Remove the top cover. See "Top cover removal" on page 4-7 for more information. 2. Remove the right side cover. See "Right side cover removal" on page 4-5. 3. Remove the controller card cover. 4. Disconnect the cables J5 DRV (A), J8 LXK LSU (B), and J15 (C) from the controller card. Note: Be sure to remove the toroid before disconnecting the cables. 5. Remove three screws (D) securing the printhead. 6. Remove the printhead. Reinstallation note: • Install the new printhead by lining up the alignment knub with the indicator located at the front right-hand screw. • Be sure to place the toroid back over the cables. • Mechanically adjust the printhead, if necessary. See "Printhead assembly mechanical adjustment" on page 4-13. • Electronically adjust the printhead. This is a necessary step. See "Printhead assembly electronic adjustment" on page 4-8. 4-40 Lexmark™ E350d, E352dn