Lexmark XM7270 User Guide - Page 304
Replace jammed originals if restarting job. - adf kit
View all Lexmark XM7270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
Troubleshooting 304 Note: If you do not have a replacement imaging unit, then see the "Ordering supplies" section of the User's Guide or visit www.lexmark.com. Replace jammed originals if restarting job. Try one or more of the following: • Touch Cancel job to clear the message and cancel the scan job. • Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan job. • Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job. • Touch Finish job without further scanning to end the last successful scan job. • Touch Restart job to restart the scan job with the same settings from the previous scan job. Replace last scanned page and jammed originals if restarting job. Try one or more of the following: • Touch Cancel job to clear the message and cancel the scan job. • Touch Scan from automatic feeder to continue scanning from the ADF immediately after the last successful scan job. • Touch Scan from flatbed to continue scanning from the scanner immediately after the last successful scan job. • Touch Finish job without further scanning to end the last successful scan job. • Touch Restart job to restart the scan job with the same settings from the previous scan job. Replace maintenance kit, recommended life exceeded [80.xy] The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or contact your service representative. Replace maintenance kit to resume printing [80.xy] The printer is scheduled for maintenance. For more information, go to http://support.lexmark.com or contact your service representative. Replace missing cartridge [31.xy] Install the missing cartridge to clear the message. For more information, see "Replacing the toner cartridge" on page 253. Replace missing fuser [80.xx] 1 Install the missing fuser. For more information, see the instruction sheet that came with the replacement part. 2 From the control panel, touch Supply replaced to clear the message.