Lexmark lexmark J110 Service Manual - Page 184
RIP-EMC Shield Assembly/RIP Card Removal, Remove the six screws {B} from the shield assembly.
View all Lexmark lexmark J110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
4085-001 RIP-EMC Shield Assembly/RIP Card Removal 1. Remove the rear cover. Refer to "Rear Cover Removal" on page 4-3. 2. Remove the power supply. Refer to "Power Supply Removal" on page 4-19. 3. Disconnect (J14) RIP cable from the engine board. 4. Remove the six screws {A} from the RIP card. 5. Remove the RIP card. Note routing of cable. 6. Remove the six screws {B} from the shield assembly. 7. Remove the shield assembly. Note: Anytime the RIP card is replaced, a course alignment has to be done. Refer to "Coarse Alignment" on page 3-5. 4-24 Service Manual
4-24
Service Manual
4085-001
RIP-EMC Shield Assembly/RIP Card Removal
1.
Remove the rear cover. Refer to
“Rear Cover Removal” on
page 4-3
.
2.
Remove the power supply. Refer to
“Power Supply Removal” on
page 4-19
.
3.
Disconnect (J14) RIP cable from the engine board.
4.
Remove the six screws {A} from the RIP card.
5.
Remove the RIP card. Note routing of cable.
6.
Remove the six screws {B} from the shield assembly.
7.
Remove the shield assembly.
Note:
Anytime the RIP card is replaced, a course alignment has to
be done. Refer to
“Coarse Alignment” on page 3-5
.