LiftMaster EL1SS EL1SS Installation and Programming Manual - Page 16
Programming, General Instruction, Enable Intercom No Telco Mode
View all LiftMaster EL1SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
INTRODUCTION INSTALLATION TESTING PROGRAMMING GENERAL INSTRUCTION NOTE: Use the STAR Key "*" to cancel any input. PROGRAMMING INSTRUCTION General Programming Code Programming Relay Programming Level Adjustment SYNTAX Master Code + Command Master Code + Command + Code Master Code + Command + Setting Master Code + Command + Setting KEYSTROKES 1234 + 1 (12,123) 1234 +1(12) + 1234 1234 + 123 + 1234 1234 + 12 + 1-3 NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high success tone). Stop and go keystrokes will result in negative tones (low single and triple fail tones). CHANGE THE MASTER CODE 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 9 The unit will beep. 3. Enter: # # # 4. Enter the new Master Code: ? ? ? ? The unit will beep. Write down the Master Code and store in a secure location. ENABLE PARALLEL RELAY OUTPUT (DEFAULT) 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 2 1 ENABLE INDEPENDENT RELAY OUTPUT CONTROL 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 2 3 ENABLE TELCO (NO INTERCOM) MODE Telco Mode is using the main telephone line for the unit's communications to the house or complex. 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 4 ENABLE INTERCOM (NO TELCO) MODE Intercom Mode is a stand alone system that allows communication between the unit and a resident's phone 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 3 MICROPHONE SENSITIVITY Allows the resident to hear the visitor at the unit, 1 = Low, 2 = Medium and 3 = High. Default level is 2. 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 7 3. Enter the Volume Level: 1 or 2 or 3 SPEAKER VOLUME Allows the visitor to hear the resident at the unit, 1 = Low, 2 = Medium and 3 = High. Default level is 2. 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 6 3. Enter the Volume Level: 1 or 2 or 3 ADJUST RELAY OUTPUT TIME (RELAY 1) The amount of time (in seconds) the relay remains active. Default level is 0.5 seconds. 1. Enter the Master Code: ? ? ? ? 2. Enter the Program Code: 0 2 4 3. Enter the Output Time (in seconds): ? ? ? ? Example: 0000 = 0.5 Seconds (Minimum) 0010 = 10 Seconds 8000 = 8000 Seconds (Maximum) 14