LiftMaster EL1SS EL1SS Installation and Programming Manual - Page 9
Wiring A Gate Operator (normally Open), Wiring An Auto-call Sensor, Introduction, Programming, Testing
View all LiftMaster EL1SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INTRODUCTION INSTALLATION TESTING PROGRAMMING WIRING A GATE OPERATOR (NORMALLY OPEN) The gate operator can be connected to Relay 1 or Relay 2. See the Programming section for information about configuring Relays 1 and 2. • Wire connectors can be removed to simplify wiring. • DO NOT overload wire connectors. Use ONLY one wire per hole. COM (Common) NO (Normally Open) Primary Gate Operator (Strike Open Input) WIRING AN AUTO-CALL SENSOR The Auto-Call feature will enable the unit to contact the resident when a driveway sensor (or any device that provides a contact closure) is activated. NO (Normally Open) 7 Loop Detector Loop Sensor
INTRODUCTION
PROGRAMMING
TESTING
INSTALLATION
7
Loop Sensor
NO
(Normally Open)
Loop
Detector
WIRING A GATE OPERATOR (NORMALLY OPEN)
Primary Gate
Operator
(Strike Open Input)
NO
(Normally Open)
COM
(Common)
The gate operator can be connected to Relay 1 or Relay 2. See the
Programming
section for information about configuring
Relays 1 and 2.
The Auto-Call feature will enable the unit to contact the resident
when a driveway sensor (or any device that provides a contact
closure) is activated.
WIRING AN AUTO-CALL SENSOR
•
Wire connectors can be removed to simplify
wiring.
•
DO NOT overload wire connectors. Use
ONLY one wire per hole.