LiftMaster EL1SS EL1SS Installation and Programming Manual - Page 21
Direct Commands From The Keypad, Telephone Programming, Programming Number, Description Of Task
View all LiftMaster EL1SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
INTRODUCTION INSTALLATION TESTING PROGRAMMING DIRECT COMMANDS FROM THE KEYPAD KEYSTROKES ACTION User Code + 1 Triggers Relay 1 User Code + 2 Triggers Relay 2 AUDIO FEEDBACK FROM THE EL1SS: 1 Low Tone Beep = Failure 2 Two High Tone Beeps = Valid sequence 3 Low Tone Beep = Error or invalid sequence NOTE: Use the STAR Key "*" to cancel any input. NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high tone). Stop and go keystrokes will result in negative tones (low single and triple fail tones). TELEPHONE PROGRAMMING PROGRAMMING NUMBER DESCRIPTION OF TASK **01 Enable Call Forwarding **02 Disable Call Forwarding **03 Enable Intercom Mode **06 Verify Call Forwarding Number (Via Caller ID) **07 Enable Telco Mode **#8 Erase Call Forwarding Number **10 Adjust Ring Count **13 Enable Alternate DTMF Programming **14 Enable Standard (Long) Ring Tone **15 Enable Alternate (Dual) Ring Tone #*16 Disable Alternate DTMF Programming *# Call Forwarding Number # Enter Call Forwarding Telephone Number FACTORY SETTING Disabled Disabled Disabled PROGRAMMING PROCEDURE **01 **02 **03 **06 Disabled 5 Disabled Enabled Enabled **07 **#8 **10 + Ring Count (2-5) **13 **14 **15 **16 *# + Telephone Number (Up to 14 digits) + # 19