Mackie PPM1012 Owner's Manual - Page 3
Read - pdf
View all Mackie PPM1012 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Owner's Manual Read This Page! We realize that you must be really keen to try out your new powered mixer. Please read the safety instructions on page 2 and this page, and the rest can wait until you're ready. But please read it - you'll be glad you did. Setup Don't use guitar cords for speaker cables! They're not designed to handle speaker-level signals and could overheat. Set the levels It's not even necessary to hear what you're doing to set optimal levels. But if you'd like to: Plug headphones into the phones output jack, then turn up the phones knob just a little. Make sure there is at least 6 inches of airspace behind the powered mixer for ventilation. There are two fans inside to cool the power amplifier section. Use the powered mixer in a nice clean environment, free from dryer lint and dust bunnies. Zero the controls 1. Fully turn down all the faders and controls, except for the channel EQ, graphic EQ faders, and pan controls, which should be centered. 2. Make sure all buttons are in the out position. Connections 1. Make sure the AC power switch is off before making any connections. 2. Push the linecord securely into the IEC connector on the rear panel, and plug it into a 3-prong AC outlet that is properly configured for the voltage of your powered mixer. 3. Plug a balanced microphone into one of the mic XLR (3-pin) connectors. Or connect any linelevel signal (keyboard, or guitar preamp) to a line input jack using a TS or a TRS 1/4" plug. 4. If your microphone requires phantom power, press in the 48V phantom power button. 5. You can connect a guitar directly to line inputs 7 or 8 without need for a DI box. Press the hi-z switch on these channels if you do. 6. The insert jacks can be used to connect an external effects or dynamics processor into the signal chain. See page 13 for more details. 7. Plug the speakers (4 ohms or greater) into the speaker output jacks on the rear panel. If you plug two speakers into a side, each speaker must be 8 ohms or greater to maintain a 4-ohm minimum load on the amplifier. Use at least 18 gauge speaker cable with 1/4" TS plugs. For now, set the power amp mode switch to stereo mains. 1. Turn on the PPM1012 by pressing the top edge of the power switch. 2. For one channel, press the solo switch in, and the rude solo light will turn on. 3. Play something into that input at real-world levels. 4. Adjust that channel's gain control until the left main meter stays around the 0 dB LED (marked "level set"). 5. Disengage the channel's solo switch. 6. Repeat steps 2 to 5 for the remaining channels. 7. In normal playing, the channel's OL LED should only light occasionally. If it stays on for a large portion of your performance, check that the gain control is set correctly. 8. Turn up the channel faders to the "U" mark. 9. Slowly turn up the main level fader until you hear the signals in your speakers. 10. If needed, apply some EQ wisely. 11. Adjust the channel faders to get the best mix. Keep the gain controls and faders fully down on unused channels. Other Notes • Only connect the powered mixer's speaker-level outputs to passive loudspeakers. • For optimum sonic performance, the channel faders and main mix fader should be set near the U (unity gain) markings. • When shutting down, turn off any external amplifiers first. When powering up, turn on any external amplifiers last. This will reduce the chance of turn-on or turn-off thumps in your speakers. • Save the shipping box! Part No. SW0704 Rev. E 05/09 ©2009 LOUD Technologies Inc. All Rights Reserved. PDF pixels home grown and harvested in Woodinville, WA. Owner's Manual