Maytag MER6875BAS Use and Care Guide - Page 10

To cancel the Clock display: If you do not want the time of day to display: Press and hold the upper oven CANCEL and Clock pads for three seconds. The time of day will disappear from the display. When the clock display is canceled, press the Clock pad to briefly display the time of day. To restore the Clock display: Press and hold the upper oven CANCEL and Clock pads for three seconds. The time of day will reappear in the display. Timer Each timer can be set from one minute (00:01) up to 99 hours and 59 seconds (99:59]. The timers can be used independently of any other oven activity. They can also be set while another oven function is operating. The Timers do not control the oven. To set the Timer 1 or 2: 1. Press the Timer 1 or 2 pad. • 00:00 and TIMER 1 or 2 flash in the display. 2. Press the appropriate number pads until the correct time appears in the display. • The colon and TIMER 1 or 2 will continue to flash. • TIMER 1 or TIMER 2 will be displayed. If both timers are active, TIMER 1 and TIMER 2 will be displayed. 3. Press Timer pad again or wait four seconds. ° The colon stops flashing and the time begins counting down. • The last minute of the timer countdown will be displayed in seconds. 4. At the end of the set time, one long beep will sound and "End" will be displayed. 5. Press the Timer pad to clear the display. To cancel the Timer: 1. Press and hold tile corresponding Timer pad for three seconds. OR 2. Press the Timer pad and press '0' using 0 the number pads. Locking the Control and Oven Doors The touchpad and oven doors car/be locked for safety, cleaning, or to prevent unwanted use. The touchpads will not function when locked. If an oven is currently in use, the touchpads and doors cannot be locked. The current time of day will remain in the display when the touchpads and doors are locked. To lock both doors: 1. Press and release CANCEL pad. 2. Press and hold the upper oven CANCEL and Cook & Hold pads for three seconds. • OFFappears in the display ° LOCK flashes while the doors are locking. Both oven doors lock. LOCK remains in the display. To unlock both doors: Press and hold tile upper oven CANCEL and Cook & Hold pads for three seconds. OFF disappears from the display and LOCK flashes while the doors are unlocking. Important: The touchpads and oven doors cannot be locked if the oven temperature is 400° F or above. Fault Codes BAKE or LOCK may flash rapidly in tile display to alert you if there is an error or a problem. If BAKE or LOCK flash in the display, press CANCEL pad. If BAKE or LOCK continue to flash, disconnect power to the appliance. Wait a few minutes, and then reconnect power. If the flashing still continues, disconnect power to the appliance and call an authorized servicer. Adjusting Sound Level The factory default setting for sound is medium (MEd), but it can be changed to low (LO) or high (HI). To change the setting: 1. Press and hold Delay and upper oven CANCEL pads for three seconds. A beep will sound. "bEEP" and the current sound level CLO", "MEd" or "HI") will appear in the display. 2. Press the Autoset pad to increaseor decrease the sound level. 3. Wait four seconds and the new setting will be accepted. 4. If the Autoset pad is not pressed within 30 seconds, the control will return to the existing setting. Changing Temp °F/°C The factory default setting for temperature is Fahrenheit. To change the setting: 1. Press and hold the upper oven Bake and CANCEL pads for three seconds. A beep will sound and the current setting (°F or °C) will appear in the display. 9