Maytag MGDE500W Use and Care Guide - Page 12

em_: v n_!!A_ ce _4 a_ed Li_ From Inside the Dryer Cabinet I.int should be removed every 2 years, or more often, depending on dryer usage. Cleaning shouldbe done by a qualified person. From the Exhaust Vent I.int should be removed every 2 years, or more often, depending on dryer usage. 0 Install and store your dryer where it will not freeze. Because some water may stay in the hoses, freezing can damage your dryer. If storing or moving your dryer during freezing weathec winterize it. Non-Use or Vacation Care Operate your dryer only when you are at home. If you will be on vacation or not using your dryer for an extended period of time, you should: 1. Unplug dryer or disconnect power. 2. Gas models only: Close shutoff valve in gas supply line. 3. Clean lint screen. See "Cleaning the I.int Screen." 4. Turn off the water supply to the dryer. This helps to avoid unintended flooding (due to a water pressure surge) while you are away. Moving care For power supply cord-connected dryers: 1. Unplug the power supply cord. 2. Gas models only: Close shutoff valve in gas supply line. 3. Gas models only: Disconnect gas supply line pipe and remove fittings attached to dryer pipe. 4. Gas models only: Cap the open fuel supply line. 5. Steam models only: Shut off water faucet. 6. Steam models only: Disconnect the water inlet hose from faucet, then drain the hose. Transport hose separately. 7. Make sure leveling legs are secure in dryer base. 8. Use masking tape to secure dryer door. For direct-wired dryers: Reinstalling the dryer Follow the "Installation Instructions" to locate, level, and connect the dryen Water Inlet Hoses Replace inlet hoses and hose screen after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses, record the date of replacement. To winterize dryer 1. Unplug dryer or disconnect powen 2. Gas models only: Close shutoff valve in gas supply line. 3. Shut off water faucet. 4. I)isconnect water inlet hose from faucet and drain. To use dryer again 1. Flush water pipes. Reconnect water inlet hose to faucet. Turn on water faucet. 2. Plug in dryer or reconnect power. 3. Gas models only: Open shutoff valve in gas supply line. The dryer light automatically you open the door. turns on inside the dryer drum when To change the drum light 1. Unplug dryer or disconnect power. 2. Open the dryer door. I_ocate the light bulb cover on the back wall of the dryer. Remove the screw located in the lower right corner of the cover. Remove the cover. Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Disconnect powen 2. Disconnect wiring. 3. Steam models only: Shut off water faucet. 4. Steam models only: I)isconnect the water inlet hose from faucet, then drain the hose. Transport hose separately. 5. Make sure leveling legs are secure in dryer base. 6. Use masking tape to secure dryer door. 12 3. Turn bulb counterclockwise. Replace the bulb with a 10-watt appliance bulb only. Replace the cover and secure with the screw. 4. Plug in dryer or reconnect power.